1. Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

    Dismiss Notice

98 3.8 to 5.0 swap

Discussion in 'All Other Conversions' started by Wishihadmoney4parts, Nov 15, 2015.

?

What do you think was or is my biggest obstacle with this swap?

  1. Wiring

    3 vote(s)
    100.0%
  2. Suspension

    0 vote(s)
    0.0%
  3. Engine mounts

    0 vote(s)
    0.0%
  4. Drive train

    0 vote(s)
    0.0%
Multiple votes are allowed.
  1. Wishihadmoney4parts

    Wishihadmoney4parts New Member

    Messages:
    3
    Likes Received:
    3
    Trophy Points:
    3
    They said not to do it , that it couldn't be done but I'm doing it anyway.
     

    Attached Files:

    ModFoxMustangs and Bill like this.
  2. Bill

    Bill Well-Known Member Staff Member Donator

    Messages:
    1,401
    Likes Received:
    240
    Trophy Points:
    93
    Welcome to the site. Keep us posted on your progress. I see no reason why you coyote would be any different that putting one in a Fox. The chassis is the same. The bolt in part should be straight forward. There are a couple of drive by wire installs on here that might help you.
     
  3. Wishihadmoney4parts

    Wishihadmoney4parts New Member

    Messages:
    3
    Likes Received:
    3
    Trophy Points:
    3
    image.jpeg image.jpeg image.jpg Got the engine and transmission all lined out and new mouths all bolted in. Rear end is in plum and bolted up. Just a few more wires to hook up and running all the simple things such as hoses and vaccum lines then she's ready to roll.
     
    ModFoxMustangs likes this.

Share This Page