benstein IBC
Active Member
so my question is this i took off all the hydro boost components of a 96 cobra and was wondering if i needed to run the abs set up by the core support or can i eliminate it, also do i need to run a porportioning valve?
Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
You will need to run the proportioning valve. If you don't, you will either tend to induce snap steer or brake bias steering. Neither is fun on the street or track.so my question is this i took off all the hydro boost components of a 96 cobra and was wondering if i needed to run the abs set up by the core support or can i eliminate it, also do i need to run a porportioning valve?
Thank youI don't have abs either, although it wouldn't be too hard to set up, would just need to run the lines for the two rear. As for the hydroboost, I used some adapters to go from m10 and m12 bubble flare that the hydro uses to double flare fittings and made the lines to go myself.